Cafe Creamy™
Automatic Milk Frother
Instruction and Recipe Booklet
EM0180
Please read these instructions carefully
and retain for future reference.
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS FOR YOUR SUNBEAM
™
• Never fill the jug above the ‘max’ indication as
hot contents may be ejected.
CAFE CREAMY
.
• After foaming and heating milk the empty
appliance needs approximately 4 minutes to cool
down. The appliance can only be operated again
after cooling.
• Do not touch the heating element surface during
or after operation as this may result in burning.
• Always use the handle on the milk jug when using
this appliance.
• Intended for heating, foaming and blending milk
only.
• Only operate the appliance when the milk jug is
correctly attached.
• The milk frother is only intended for use with the
jug provided.
• Do not insert foreign objects such as knives or
forks into the milk jug while in operation.
• Always secure the milk jug lid before operation,
as hot contents may be ejected during use.
• Only operate when the milk jug is filled above the
‘min’ indication. Do not use when empty.
Sunbeam is very safety conscious when designing • Do not use an appliance for any purpose
and manufacturing consumer products, but it is
essential that the product user also exercise care
when using an electrical appliance. Listed below
are precautions which are essential for the safe
use of an electrical appliance:
• Read carefully and save all the instructions
provided with an appliance.
other than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
• Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug
when the appliance is not in use and
before cleaning.
• Do not use your appliance with an extension
cord unless this cord has been checked
and tested by a qualified technician or
service person.
• Always use your appliance from a power
outlet of the voltage (A.C. only) marked
on the appliance.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
• Do not operate any electrical appliance with
a damaged cord or after the appliance has
been damaged in any manner. If damage is
suspected, return the appliance to the nearest
Sunbeam Appointed Service Centre
for examination, repair or adjustment.
• For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
• Do not immerse the appliance in water
or any other liquid unless recommended.
• Appliances are not intended to be operated
by means of an external timer or separate
remote control system.
• This appliance is intended to be used in
household and similar applications such
as: staff kitchen areas in shops, offices and
other working environments; farm houses; by
clients in hotels, motels and other residential
type environments; bed and breakfast type
environments.
• Children should be supervised to ensure that
they do not play with the appliance.
• The temperature of accessible surfaces may be
high when the appliance is operating.
• Never leave an appliance unattended while
in use.
If you have any concerns regarding the performance and use of your appliance,
Ensure the above safety precautions are understood.
1
Features of your Sunbeam
Cafe Creamy™
Plastic Lid
Ensures no spillage while heating, foaming or
blending milk.
Foam Blender Attachment (Labelled ‘FOAM’)
Create hot, foamed milk for your coffee.
Jug Handle
Allows easy handling before and after
operation, and while milk jug is hot.
Milk Jug
250mL capacity is large enough to create
frothy milk for two standard coffees.
Easily removed for cleaning.
Push Button Control Panel
Easy to use control panel delivers cold milk,
hot milk or foamed milk.
2
Filling level indicators
With ‘max’ and ‘min’ level indication marks
Power base
With a powerful 650W element for heating,
foaming and blending milk quickly.
Automatic Temperature Control
Ensures milk does not burn during heating
and foaming process.
Accessory Storage
Blending attachments can be stored easily
underneath the power base, clipping into
place using magnets.
Accessories
Milk Mixing Attachment (Labelled ‘MIX’)
Blends chocolate powder with milk to create
either hot chocolate or cold chocolate drinks.
Foam Blender Attachment (Labelled ‘FOAM’)
Create hot, foamed milk for your coffee.
Cord Storage
Non-slip rubber feet
Makes the unit sturdy, preventing it from
slipping or scratching the bench top.
3
Using your Cafe Creamy™
Automatic Milk Frother
Before using your Cafe Creamy™ Automatic
Milk Frother for the first time, wash the milk
jug and plastic lid in warm, soapy water.
Rinse and dry thoroughly. Repeat with the
foam and milk mixing attachments located
underneath the power base.
Note: Do not immerse the power base in
water or any other liquid, or allow moisture
to come into contact with these parts.
See Figure 1.
Preparing Hot Milk Beverage with Foam
1.Remove the milk jug from the power base.
2.Open the lid of the milk jug and insert the
foam blender attachment into the base of
the milk jug.
3.Pour milk into the milk jug, to a maximum
of 250mL, the level that is marked with
‘M’ for max. See Figure 3.
Tip: To create a frothy hot chocolate, simply
add 1-2 tablespoons of chocolate powder.
Figure 1
Figure 3
Note: If you fill the milk jug above the
maximum level, hot milk may be ejected
during operation.
Note: The milk jug must also be filled above
the minimum level, as indicated by ‘O’
symbol, to operate properly.
4.Secure the lid onto the milk jug
5.Plug the power cord into a 230-240V AC
power outlet and switch the power on and
place the milk jug on the heating element
on the power base.
Note: The appliance does not have an on/
off button. Functions are activated through
pressing feature buttons located on the
control panel.
Figure 2
Note: Do not place any part of the appliance
in the dishwasher.
Note: To stop the appliance at any time, press
the button on the control panel originally
activated again.
4
™
Using your Cafe Creamy Automatic Milk Frother (continued)
Preparing Hot Milk Beverages
1.Remove the milk jug from the power base.
6.Press the
foam milk button to begin the
milk foaming function. In approximately
1 to 2 minutes, dependent on the volume
of milk, the appliance will automatically
switch off and you will be left with hot,
foamed milk in the milk jug.
Note: The foam milk button selected will
remain illuminated during operation, and will
turn off automatically when the milk foaming
is complete.
Note: Only remove the milk jug from the
power base to pour using the jug handle, as
the milk jug body may be hot. Do not drink
directly out of the milk jug.
2.Open the lid of the milk jug and insert the
milk mixing attachment into the base of
the milk jug.
3.Pour milk into the milk jug, to a maximum
of 250mL, the level that is marked with
‘M’ for max. See Figure 3.
Note: If you fill the milk jug above the
maximum level, hot milk may be ejected
during operation.
Note: The milk jug must also be filled above
the minimum level, as indicated by ‘O’
symbol, to operate properly.
Note: Flashing control panel lights indicate
the appliance is cooling down. Please wait
approximately 4 minutes before restarting the
appliance.
7.Follow cleaning instructions in the ‘Care
and Cleaning Instructions’ section of this
manual found on page 7, after use to
ensure long life.
4.Add 1-2 tablespoons of chocolate powder
or an espresso shot and secure the lid onto
the milk jug
5.Plug the power cord into a 230-240V AC
power outlet and switch the power on and
place the milk jug on the heating element
on the power base.
Note: This appliance does not have an on/
off button. Functions are activated through
pressing feature buttons located on the
control panel.
6.Press the
mix hot milk button to
begin the milk blending function. In
approximately 1 to 2 minutes, dependent
on the volume of milk, the appliance will
automatically switch off and you will be
left with a hot milk beverage in the milk
jug.
Note: The blend milk button selected will
remain illuminated during operation, and will
turn off automatically when the milk blending
and heating is complete.
Note: Only remove the milk jug from the
power base to pour using the jug handle, as
the milk jug body may be hot. Do not drink
directly out of the milk jug.
5
™
Using your Cafe Creamy Automatic Milk Frother (continued)
Note: Flashing control panel lights indicate
the appliance is cooling down. Please wait
approximately 4 minutes before restarting the
appliance.
Note: The blend cold milk button selected
will remain illuminated during operation,
and will turn off automatically when the milk
blending and heating is complete.
7.Follow cleaning instructions in the ‘Care
and Cleaning Instructions’ section of this
manual found on page 7, after use to
ensure long life.
7.Follow cleaning instructions in the ‘Care
and Cleaning Instructions’ section of this
manual found on page 7, after use to
ensure long life.
Preparing Cold Milk Beverages
1.Remove the milk jug from the power base.
2.Open the lid of the milk jug and insert the
milk mixing attachment into the base of
the milk jug.
3.Pour ice-cold milk into the milk jug, to
a maximum of 250mL, the level that is
marked with ‘M’ for max. See Figure 3.
Note: If you fill the milk jug above the
maximum level, milk may be ejected during
operation.
Note: The milk jug must also be filled above
the minimum level, as indicated by ‘O’
symbol, to operate properly.
4.Add 1-2 tablespoons of chocolate powder,
instant coffee or an espresso shot.
5.Plug the power cord into a 230-240V AC
power outlet and switch the power on and
place the milk jug on the heating element
on the power base.
Note: The appliance does not have an on/
off power button. Functions are activated
through pressing feature buttons located on
the control.
6.Press the
mix cold milk button to
begin the cold milk blending function. In
approximately 3 minutes, the appliance
will automatically switch off and you will
be left with cold milk beverage in the milk
jug. Pour into a glass filled with ice to
keep cool.
6
Care and Cleaning Instructions
Always disconnect the Cafe Creamy™ from
the power outlet before cleaning any parts.
Cleaning the Milk Jug and Blending Attachment
after use
After removing the milk jug from the power
base and emptying its contents, wait for
the milk jug to cool down. Then remove the
blender attachment from the base of the milk
jug. When cleaning the inside of the milk jug
and blending attachment, hand-wash only
using a sponge or a soft brush together with
normal dish washing liquid. Be careful when
cleaning the base of the milk jug where the
heating element has contact, as it must not
be scratched.
Note: Before cleaning after use, wait for the
appliance to cool down.
Note: Do not immerse the power base in
water or any other liquid, or allow moisture to
come into contact with these parts.
See Figure 1.
Note: Do not place any part of the appliance
in the dishwasher.
Preparing for use
Before using your Cafe Creamy™ Automatic
Milk Frother for the first time, wash the milk
jug and plastic lid in warm, soapy water.
Rinse and dry thoroughly. Repeat with the
foam blender and milk mixing attachments
located underneath the power base.
Cleaning the power base in case of spillage
If milk spills onto the power base, switch off
the power outlet immediately and remove the
plug. Using a damp cloth gently wipe spillage
from power base. Ensure appliance is dry
before plugging into power outlet.
Note: Do not use any solvents or abrasive
agents for cleaning. Do not use and sharp
or hard instruments such as steel wool for
cleaning.
7
Notes
12 Month Replacement Guarantee
In the unlikely event that this appliance develops any malfunction
within 12 months of purchase (3 months commercial use) due to
faulty materials or manufacture, we will replace it for you
free of charge.
Should you experience any difficulties with
your appliance, please phone our customer
service line for advice on 1300 881 861 in
Australia, or 0800 786 232 in New Zealand.
Alternatively, you can send a written claim
to Sunbeam at the address listed below.
On receipt of your claim, Sunbeam will
seek to resolve your difficulties or, if the
appliance is defective, advise you on how
to obtain a replacement or refund.
In Australia you are entitled to a
replacement or refund for a major failure and
for compensation for any other reasonably
foreseeable loss or damage. You are also
entitled to have the goods repaired or
replaced if the goods fail to be of acceptable
quality and the failure does not amount to
a major failure.
Should your appliance require repair or
service after the guarantee period, contact
your nearest Sunbeam service centre.
Your Sunbeam 12 Month Replacement
Guarantee naturally does not cover misuse
or negligent handling and normal wear and
tear.
For a complete list of Sunbeam’s authorised
service centres visit our website or call:
Australia
Similarly your 12 Month Replacement
Guarantee does not cover freight or any other
costs incurred in making a claim. Please
retain your receipt as proof of purchase.
1300 881 861
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
The benefits given to you by this guarantee
are in addition to your other rights and
remedies under any laws which relate to the
appliance.
New Zealand
0800 786 232
26 Vestey Drive, Mt Wellington
Auckland, New Zealand
Our goods come with guarantees that cannot
be excluded under the Australian Consumer
Law and under the New Zealand Consumer
Guarantees Act.
Need help with your appliance?
Contact our customer service team or visit
our website for information and tips on
getting the most from your appliance.
In Australia
Or call 1300 881 861
In New Zealand
Or call 0800 786 232
is a registered trademark.
‘Cafe Creamy™’ is a trademark of Sunbeam Corporation.
Made in China.
Due to minor changes in design or otherwise,
the product may differ from the one shown in this leaflet.
© Copyright. Sunbeam Corporation Limited 2010.
ABN 45 000 006 771
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
Unit 3, Building D
26 Vestey Drive
Mt Wellington Auckland
New Zealand
Sunbeam Corporation is a division of GUD Holdings Ltd.
9/11
|